HALO-1 LEDウインカー

・スモーク／クリアレンズ
・5つのカラーオプション
・プラグ＆プレイ
・グロウィングランニングライト
・入数：ターンシグナルセット(左右)
・マウントパーツ・説明書
※取り扱い説明書が付属する場合は英語となります。
プラグアンドプレイの取り付けは、純正プラグに3本の導体があるアメリカモデルで確認されています。アメリカ以外から注文する場合は、まず信号プラグを確認してください。プラグの導体が2本しかない場合は、よくある質問のインストール手順に従ってください。
このアイテムはDOTは承認しておらず、お住まいの地域の法律および規制に準拠していない可能性があります。
These Halo-1 Flushmount Turn Signals fit flush within your fairing and provide a glowing halo effect in running light mode in a variety of colors．
The Halo-1 technology is another big innovation by TST Industries．
Two years in the making， this product took a lot of R＆D to design just right．
With the most advanced optics in the flushmount signal market， a shape that is contoured to the outer geometry of the fairing and fits perfectly within the signal well， and true plug-and-play installation， this system has proven to be a hit！
The running light function has a glowing halo (patent pending) in a color of your choice．
During signaling， the halo element turns off to eliminate color bleed．
The signaling circuit packs three 1W amber LED chips that fire a super bright signal through a lens packed with light dispersing hexagonal dome optical elements．
As a result， you have a very bright and noticeable signal lamp that can be easily seen from the front and side．
The installation takes just minutes by simply plugging the signal into the harness， pushing it into the fairing well， and fastening it down with the provided hardware．


【FAQ】
Q: The signals have a 3 pin connector but my signals only have 2．
How do I install？
A: Some bikes outside of North America will only have 2 pins．
For bikes with a two pin signal plug you would take the pins out of the three conductor plug on the halo-1 signals．
The wires in our plug have crimped on metal connectors．
You will insert the halo-1 black wire crimp into your plug position that has the green wire．
Then the halo-1 red wire crimp will go into the remaining slot on your bike’s plug．
Use electrical tape around the plug with the pins in it and make a nice tight electrical tape junction．
You will be left with the green wire from the halo-1 signals．
If you leave it disconnected you will not have the running light．
At this point you can run a wire from the positive lead on your low beam headlight to each of the green wires on the halo-1’s．
This will give you running lights when the bike is on， and they will shut off with the bike．
You can also opt to run a wire to the positive terminal on the battery and use a fuse and a switch on that connection．
The fuse should be immediately next to the battery， and the switch should be accessible somewhere for you so you can switch the halo-1 running light on and off at your will．

ユーザのインプレッションを見る

適合車種： CBR600RR ( 適合車種を見る )